Problems That Require A Call To A Plumber | Burleson, TX
You rely on your plumbing system all day, and plumbing issues can make life in your home challenging. The system consists of three parts, the water delivery system, the drainage system, and fixtures and equipment. If any part of the system isn’t working correctly, a DIY repair isn’t recommended, and it’s best to hire a licensed professional.
If your plumbing system experiences any of the following problems, it’s best to hire a plumber in Burleson, TX, immediately.
#1 Leaks
Plumbing leaks occur when your pipes rust and corrode over time. The same applies if a joint becomes loose or disconnected or the seal fails. A plumbing leak is a serious problem because water damage and mold growth can occur in the area around the leak. Also, the leak will waste a significant amount of water, causing your water bills to increase. Finally, the leak can cause poor water pressure in the rest of the house, so it’s best to hire a plumber immediately.
Leaks in some areas are easy to detect, such as a leak under the sink, because you’ll see the water pooling. Leaks behind a wall can also be easy to spot because you’ll see water spots on the wall around the leak. However, leaks in some areas can be challenging to detect, such as a leak under the house, and you’ll need to know what to look for, including:
- A warm basement floor or the flooring on the first floor
- Damp first-floor carpeting
- Warped floors on the first floor
- Puddles inside the house, especially near the washing machine.
- Puddles by your house, even though it hasn’t rained
- Damage to your home’s foundation
Sometimes, you won’t see any visible signs, and the leak will reduce the water pressure or increase your water bills.
A licensed plumber can replace the pipe, tighten the joint, and replace the seal, depending on the leak’s cause. If they can’t find the leak’s location, leak detection equipment will help them pinpoint the site to make the necessary repair. Because plumbing leaks can be 0damaging, it’s best to make the call immediately.
#2 Dripping Faucet
It’s easy to consider a dripping faucet a minor nuisance because it won’t affect your ability to use the sink or tub. However, a dripping faucet is more serious than you think. A faucet that drips one drop per second can waste up to 330 gallons of water per month, causing your water bills to increase considerably. Also, the dripping can escalate to a steady stream over time, wasting even more water.
Your faucet can drip due to a few reasons, including:
- A worn-out washer or gasket
- A loose O ring
- Corrosion in the valve seat
- The faucet reached the end of its lifespan
A licensed plumber will inspect the faucet to determine if it can be repaired or if a replacement is the best option, preventing you from wasting more water.
#3 Running Toilet
Your toilet should run after every flush to fill the tank, so it’s ready for the next flush. If the toilet continues running even after the tank is full, it’s best to hire a plumber in Burleson, TX.
A running toilet wastes much more water than a dripping faucet, wasting up to 900 gallons a month and causing your water bill to increase significantly.
A few problems can cause the toilet to run constantly, including:
- Cracked or damaged flapper
- Broken or tangled chain
- The float height needs to be adjusted
- The refill tube is too long
- The toilet has reached the end of its lifespan
A licensed plumber will inspect the toilet to determine the cause and make the necessary repairs so that you won’t waste any more water and your bills will go back to normal.
#4 Water Heater Issues
Your water heater is technically an appliance, and it’s also an essential part of your plumbing system. The unit fills with water, where it’s heated and stored, so you always have hot water when needed. Water heater issues can affect the water temperature and safety and could cause a flood in your home, and it’s best to hire a licensed plumber if the unit experiences any of the following problems.
- The unit sounds like it’s possessed.
- Moisture or water pooling around the unit
- You have no hot water.
- The water doesn’t get hotter than lukewarm.
- You frequently run out of hot water.
- Poor hot water pressure
- Brown or rust-colored water
DIY water heater repair isn’t recommended because you can do more damage, resulting in a more expensive repair bill. Also, if the unit is still under warranty, a DIY repair will void it, and you’ll need to pay for future repairs yourself.
A plumber in Burleson, TX, will inspect the unit to diagnose the problem and make the necessary repairs to allow the unit to function correctly. Some issues can escalate to something more serious, so it’s best to make the call as soon as you suspect there’s a problem.
Call Benjamin Franklin Plumbing of Fort Worth Today
If you have a plumbing problem and need to hire a licensed plumber, look no further than Benjamin Franklin Plumbing of Fort Worth. We’re a full-service plumbing company, serving customers in the area since 1998.
Our plumbing techs are professionally trained, licensed, bonded, and have the knowledge and skill to tackle the most challenging jobs in the plumbing industry. Our team is available 24 hours a day, seven days a week, to handle plumbing emergencies. We’ll get tech to your home as quickly as possible to resolve the problem.
Our tech will arrive at your home in a fully-stocked truck, allowing them to make most repairs the same day, saving you money and making your life more convenient.
We’ve earned an excellent reputation over the years and are a Google Guaranteed Partner with a 5-star rating, and we’re an Accredited Business with the Better Business Bureau with an A+rating. You can also find us on Home Advisor, and we’re a Top Rated and Elite Service with over 100 reviews on the platform.
To schedule an appointment for plumbing service, give Benjamin Franklin Plumbing of Fort Worth a call or book online.
